I am preparing my new LMS server using a :
Pi4 ( 4 GB) , PCP6.0 fresh install, new powered USB3 hub, 2 or possibly more usb3 disks
And after some powercable and powersupplyunit problems I have a stable HW platform, Copied a few hundred gig with no visible issue.
And although the disks are always auto-mounted on a power-up boot, I do not get the disks to mount on a software reboot.
Before the powered hub, I could not get 2 disks to work reliably though the pi. But with only one disk a reboot was not an issue.
Is this issue something that has to do with PCP ? Or is this common with powered hubs ?
It seems the disks are not reset, but i am not sure this is true and how I can determine it.
Suggestions and solutions are welcome.
( Perhaps I should boot and reboot another linux distro to see if this is HW or PCP related. )
M-H
Pi4 ( 4 GB) , PCP6.0 fresh install, new powered USB3 hub, 2 or possibly more usb3 disks
And after some powercable and powersupplyunit problems I have a stable HW platform, Copied a few hundred gig with no visible issue.
And although the disks are always auto-mounted on a power-up boot, I do not get the disks to mount on a software reboot.
Before the powered hub, I could not get 2 disks to work reliably though the pi. But with only one disk a reboot was not an issue.
Is this issue something that has to do with PCP ? Or is this common with powered hubs ?
It seems the disks are not reset, but i am not sure this is true and how I can determine it.
Suggestions and solutions are welcome.
( Perhaps I should boot and reboot another linux distro to see if this is HW or PCP related. )
M-H
