Raspberry pi

col996s -

There is no equivalent for the Pi (a LinuxOS based system) for the Windows
Control Panel application. There are no "tabs" to be seen.

Typically one starts/stops LMS from a command line terminal. Or, if one has
used a product like piCorePlayer or Max2Play (both created for Raspberry
Pis) one uses the webpage those systems provide to start/stop LMS. For
example, I use pi/CorePlayer on my rPi3. To start/stop LMS I run a web
browser and I go to the piCorePlayer UI at http://192.168.1.67 (<-- not
192.168.1.67:9000) and the piCorePlayer webpage loads on which is an LMS
section with buttons I use to start/stop LMS.

Back when I ran LMS on a Linux desktop, I'd use a terminal application to
run the installed init script to start/stop LMS.

Hope this helps.
--

“Happiness is the meaning and the purpose of life, the whole aim and end of
human existence.”

― Aristotle


On Fri, Nov 27, 2020 at 12:08 PM col996s <
col996s.9t0e3b (AT) no-mx (DOT) forums.slimdevices.com> wrote:

>
> The problem I have when I run lms on a pc can see all the tabs. Not sure
> how to view the tabs on the pi. Can only see the Web page using ip
> address:9000 on my laptop.
>
>
> ------------------------------------------------------------------------
> col996s's Profile: http://forums.slimdevices.com/member.php?userid=60495
> View this thread: http://forums.slimdevices.com/showthread.php?t=113317
>
>