Squeezelite settings - Output setting

I was having a difficult time getting my Allo USBridge USB operating. It was finally achieved by trying a different output setting in the squeezelite settings tab of the PCP. The question I have; if more than one option works, is one better than the other? In my case the options were:



I randomly choose the following:



Is there any other tuning be done on this page?

Once the USB is working to my satisfaction I am going to install my Allo DigiOne card (not DigiOne Sig)to the USBridge board. Should that function without issue with the output setting if the USB works?

Thanks - this is a very useful forum.

Attached Images